Technology

What to Do When Netgear Orbi Firmware Update Fails?

I followed the correct instructions, my internet connection is strong, everything has been well taken care of, but then why am I facing the Netgear Orbi firmware update issue?”

If you’ve done everything right but still can’t update the firmware of your Orbi device, then the bad news is that you DID mess up at some point. But, worry not. In this article, we’ve mentioned every tip required in order to troubleshoot the Orbi firmware update failure issue. Thus, waste no further time and read on.

Resolved: Netgear Orbi Firmware Update Failure

Mentioned below are the troubleshooting tips that’ll surely help you in gettingg rid of the issue at hand. Also, with the help of these steps, you’ll be able to perform the process of firmware update without any hassle:

Power Cycle Your Orbi Device

Restarting your Netgear Orbi device is the first thing that you should do whenever it starts acting out. This is because most of the time technical issues arise because of random glitches. And restarting your device helps you in getting rid of such glitches.

Follow the guidelines mentioned below to power cycle your Netgear Orbi router:

  • Disconnect all devices connected to your Orbi.

  • Unplug the power adapter from the wall socket.

  • Power off your device and wait for some time.

  • Next, connect your device to the adapter.

  • Plug the power adapter back into the wall outlet.

  • Oh, and, don’t forget to turn on your Netgear Orbi.

After restarting your WiFi device, access orbilogin.com and try to update the firmware. Still no luck? No problem. Continue reading.

Check Your Internet Connection

Although you think that your internet connection is strong, perhaps it isn’t. Think about it – will you even be here if your internet connection was strong enough to help you update your device?

Thus, to fix this issue, make sure that your Netgear WiFi router and modem are well connected. Do not make the mistake of connecting your wirelessly. Doing so will increase the risk of you getting surrounded by a more serious internet issue. Instead, connect your devices with a cable.

Before using an Ethernet cable, keep the below mentioned points in mind:

  • Your cable should be finger-tight instead of being loose.

  • It shouldn’t have any cuts or damage from any end.

  • In case your cable has a breakage, get it replaced with a new one.

If you consider the aforementioned points, you’ll surely get rid of the Netgear Orbi firmware update failure issue. On the off chance, if the issue persists, perform factory default reset.

Reset Your Orbi Device

Walk through the instructions given below to restore your Netgear Orbi to its default settings:

  • Look for the Reset button located on your device.

  • Found it? Good. Now, take an oil pin to press the button.

  • Press the Reset button for at least 30 seconds.

After restoring your Netgear router to its factory default mode, follow the steps outlined here to update the firmware of your device:

  • Power on your Netgear Orbi router and modem.

  • Then, connect both the devices properly.

  • Install a web browser on your PC and access the orbi login page.

  • Fill in the default admin credentials and press the Enter key.

  • Once you log into your device, click on the Firmware Update button.

Were these guidelines of any hep to you in updating the firmware of your Netgear Orbi device? Feel like sharing your answer? We have just the right platform for you. And that is the comments section below. Feel free to share your experience with us at any hour of the day

About the author

Avatar

Ayushi

Add Comment

Click here to post a comment

More News

Need Your Support

Please Support Us to publish free guest post

Support

Contact

Market Research Tab Inc.
600 B Street Suite 300,
San Diego CA 92101.